3.7 out of 5 based on 34 customer ratings
34 Review(s) | Write a review

Phantom 3000W Monoblock, Class D Amplifier Dim:13"L 10.31"W 2.25"H

  • 3000 W MAX Power 1 Channel
    2250 W X 1 RMS @ 1 ohm
    1125 W X 1 RMS @ 2 ohm
    563 W X 1 RMS @ 4 ohm
    4500 W X 1 RMS Strapped Bridged Power @ 2 ohm
  • Monoblock, Class D, MOSFET Power Supply
  • Low Level Inputs, RCA Pre-amp Outputs
  • Variable Low Pass Crossover, Variable Bass Boost and Variable Subsonic Filter and Switchable Phase Control
  • Include Remote Subwoofer Control
  • Red LED Backlit Illumination
  • Dimensions: 13" L x 10.31" W x 2.25" H
California Prop 65 Warning

What is Proposition 65?

Proposition 65 is a California law that applies to companies selling products in California. Proposition 65 requires warnings if a product contains any listed chemical present above very low levels. Proposition 65’s warning standards are among the most stringent in the world. Proposition 65 is not a product safety law, but rather a "right-to-know" law. Businesses are required to provide warnings to comply with Proposition 65.

There are over 800 chemicals on the Proposition 65 list, which is administered by California's Office of Environmental Health Hazard Assessment (OEHHA), a part of the California Environmental Protection Agency. The list includes naturally occurring and man-made chemicals. Proposition 65 warnings can be seen for a wide variety of everyday consumer products, including electronic equipment, and warnings can be seen posted throughout California in a variety of establishments such as buildings, hotels, restaurants, coffee shops, and stores.

Why do you see the warning on our packaging and website?

The warning is part of our ongoing effort to comply with the California Safe Drinking Water and Toxic Enforcement Act of 1986 (known as "Proposition 65").

California Prop 65 Warning

WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

Fast, Free Shipping
U.S. Lower 48 States
60 Day Money Back
Hassle Free Returns
Standard Warranty 1 Year
Extended Warranty 2 Year
Tech Support
Live Chat or Call 805-751-4853

General Specs

Channel Configuration
1 Channel
Power Supply Type
MOSFET Power Supply
Amp Topology
Monoblock, Class D

Performance Specs

Total Power Output
3000 Watts
Peak Power @ 1 Ω
3000 Watts x 1
Peak Power @ 2 Ω
1500 Watts x 1
Peak Power @ 4 Ω
750 Watts x 1
RMS Power @ 1 Ω
2250 Watts x 1
RMS Power @ 2 Ω
1125 Watts x 1
RMS Power @ 4 Ω
563 Watts x 1
Strapped Power bridged @ 2 Ω
6000 Watts
Speaker Impedance
1 to 8 Ω
T.H.D. (Total Harmonic Distortion)
0.01 %
S/N Ratio (A-Weighted)
100 dB
Frequency Response
15 Hz to 150 Hz ±1 dB

Connections, Controls, and Processing

RCA Inputs
2 Channel
Pre Amp Outputs
2 Channel
Low Pass Filter
50 Hz to 150 Hz
Subsonic Filter
15 Hz to 40 Hz
Bass Boost
Variable 0 to 18 dB
Phase Control
0 to 180°
Subwoofer Level Control
Input Sensitivity Switch
Thermal/Overload/Short Protection


5 out of 5

Compared to a CEA Amplifier, it works well under 2 ohm and 1 ohm loads. I used 4 gauge wiring for power and ground.

I purchased the PD5000 "5000 watt max" amplifier. It works well under both 2 ohm and 1 ohm loads. At 2 ohms load, this performed just as well as my Kenwood 2000 watt max, but CEA rated, amplifier. I was surprised The output seems to proportionately increase under 1 ohm load. I did not have a db meter to confirm, nor do I have a means to dyno the amp or test the current in my wires. I used this to drive 1 and then 2 Kicker L7 15 inch subwoofers (4 ohm dvc). I am no expert, and this is basically a guess, but I feel as if output is somewhere near 2000 watts RMS, at 1 ohm, which is perfect for my driver load. This is a day one review, but if I do not update, then I have no problems.
3 out of 5

Everything lights up and it acts like its working but nothing from speaker outputs

Purchased this amp for a car I was working on. It set on a shelf for almost a year before I installed it. Played for 2 songs then stopped. Everything lights up and it acts like its working but nothing from speaker outputs. Of course since I had it so long before I installed it there is nothing they will do. I removed cover and can see where the outputs are burned. It is the worst soldering job on any electronic I have ever seen. It looks like a 5 year old built it. This amp was designed to fail! Either that or the quality control at Boss is horrible. Do not purchase! Revised 06/29/2017- After speaking with Boss they agreed to honor 6 year warranty and are going to service and repair amp for free. I have to pay shipping but that is to be expected. If all goes well and I receive amp back repaired I will update this post and revise again.
3 out of 5

Nothings perfect

Worked great! For 2 minutes. Then forced subs to pulse, and continued with smoking. Amazon quickly replaced and the new one works well, compared to a kenwood 1800 kac9104d bridged , the boss doesn't beat it by volume by any means. More so equal, now where the boss kicks is the quality I've got tuned no bass boost running 2 , yes dual kicker l7 15s in sealed 2sqft boxes ea. I'm blowing people's systems away without even cranking mine.

Read reviews on Amazon

Add a review